Announcement Announcement Module
No announcement yet.
F2 Separator clutch problems help Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • F2 Separator clutch problems help

    Your operator manual will show you how to adjust the clutch. If your clutch throw out will not go over center to lock in the engaged position you may have a lot of dust packed between the clutch disk and the drive plate. If it goes over center but will slip you will have a burning smell. If your clutch still has the cover on it loosen the three bolts a little and look behind it. You will see a ring with a lot of slots in it this is the adjusting ring. On the OD of this ring you will find a retainer that fits in two of those slots. This retainer is held in place by a 1_4" bolt. With the retainer on the bottom loosen the bolt until the ring will turn. Put a punch in any one of the slots and hit it with a hammer counterclockwise to tighten the clutch. If this ring is like most you will have to hit it quite hard to get it to move.