Combines 2388 rice equipedIJ

2388 RICE SPECIAl USUAllY COMES WITH SOME EXTENDED WEAR PARTS SUCH AS FRONT ROTOR TUB ClEANGRAIN ElEVATOR, UNlOAD SYSTEM WITH All AUGERS ON MACHINE EXTENDED WEAR EXCEPT RETURN and lAST AUGER ON UNlOADER, HEAVY DUTY REAR AXIlE, FEEDER HOUSING MAY BE lONGER,CONCAVES USUAllY HAVE EVERY OTHER WIRE TAKEN OUT, GRATES ARE KEYSTOCK GRATES, MINIMAl SETUP FOR CORN , IT'S A GOOD MACHINE IS THERE MUCH PRICE DIFFERENCE OVER A GRAIN MACHINEIJ GOOD lUCK !!!!!!

The hydro will have two oil coolers. If the machine is a 2 speed hydro, and I think it should be, the 2 speed will drop out of the high side if drive pressure exceeds about 3500 psi (I think, might be higher). The final drives whould also be different which will limit your top road speed somewhat as they are a deeper reduction than standard.

there are two oil coolers , 2speed hydro in manualy switched with a switch on the console 2nd gear hydro in high w_4wd machine speed 6.2mph roughly wo_4wd 7.6mph roughly 3rd gear hydro in lo 16.2mph adjustment can be made to get machine in high in 3rd gear machine will travel roughly 20mph in high

The final drives are the same. I have a ricer 2188 and there are some real diffs between the grain and rice machines. here is a short list. 1. the rear axle is 10 bolt wheels and stouter than grain. 2.stainless augers. 3.faster unloader sprockets. 4.they are a little hard on corn.Hard to keep it in the back if you have full rice spikes on the rotor with out kicker bars in the back. 5. they will cut damp stemmy beans like no tomorrow. 6.they have diffrent gears in the tranny I know this because I had to put a ring and pinion in mine last fall. they are the same ratio and all but they are Massive compared to a grain machine. Plus they have two oil coolers and a two speed hydro. I never used it but it was there. 7. My ricer has probaly 75 to 100 horse over my grain 2188. I'm not joking here.That thing will outrun,outcut and outpower my other combine and, the ricer has 4000+ engine hours and 3500+ sepertater hours on it! later, Will