JWK
Guest
TW Here are some items I know of. 844 grease fitting are on the front of snapping rolls. Drive sprockets for gathering chains are held on with a roll pin...this will fail in time...then you put in a 3_8" bolt. Cross auger is driven on left side...this chain is hard to oil under the CH. 944 Grease fitting for snapping rolls have a small hose that is mounted on the back plate. after time the hoses will fail and no grease gets to snap rolls. Also gear cases are alum. 1044 Gear case are back to cast iron. snapping rolls are water pump bearings and the cross auger is driven on the right side of CH. Also drive sprocket for gathering chains are key in the shaft and fastened down with a nut...no maintance there.