Combines 925 Flex Cutter Bar

[sidewinder]

I dont know if the sections are different for the 900 series over the 200 but on my 224 i had the knife bust in 2 places about 4 inches apart and it broke there a couple times... when i went to my macdon swather to get section bolts i found some extra little plates that macdon bolts ont he top side of the knife between sections.. Turns out they fit my knife close enough.. Hasnt broke in 2 years. Maybe itll work for you too... the top plates ont he knife are from a 160 macdon header on a 2360 jd swather, Ed

 

[bh]

Had the same problem on my 920 when I first got it. Got expensive and aggravating. I took the support plate off the drive end of a busted section, hammered it flat where it was bent to attach to the drive, and bolted it over the area of sections that kept breaking. Haven't been back to it in 4 years now. I'm not sure if I'm being clear enough about what I did (head foggy this am) and if I am not, respond back. This is similar if not exactly what sidewinder did. Good luck, bh