Combines 9750 wont run

[land_Surfer]

Cranks but, won't start; runs fine and dies, hmmm. If you've checked all grounds and replaced most of the boards, I would venture to say you have an engine problem related tot he fuel system. Does this combine have a power chipIJ If so, remove it. If not, have the engine's ECM, fuel injection and fuel deliver systems checked by a dealer equipped with the computer aided diagnotic tools. Also, you might even consider draining the fuel tank and inspecting it for plastic shavings, as well as replacing the fuel filter and fuel_water separator.

 

[jeff]

2001 R62 had plastic shavings in the fuel tank resuting in simular proublem. I know different machine but tank could be from same suplier.

 

[Wheaty1]

How's the 2388 runningIJ

 

[mech1]

the only trouble would be if the fuel tank vent is plugged and some how the stand pipe that sucks fuel from the bottom of fuel tank is bent this is from the top of the tank on this machine are there error codes on the display other electrical problems on these are the relay panel large solenoids get hot and shut the machine down that is why they changed the relay panel on the newer machines they can take the load better

 

[corny]

Will it resart with a shot of etherIJ If so the sump in the tank or the vent is the problem. I think there was an update for this. Mine did this, and when it resarted with ether it would run. Also had this problem with a faulty power chip.

 

[gben]

No, will noy start even with ether

 

[gben]

The fuel tank has been changed out to the new style as we did have this problem before.

 

[gben]

like a fool we backed out of the trade because of the drought, not the smartest decision we ever made!

 

[gben]

This may be our best shot so far, will try that next,thanks.

 

[mech1]

i've had this problem on an older 10 series combine and replaced everything on the machine that was fuel related and finally replaced the ecu and didn't have htis problem again this combine would die and not get started the when running it would run for three days then do it again ask dealer if the have another 9750 that htey can use the ecu off of it instead of putting a new one on.