turbored
Guest
What you are refering to as a moisture eye is actually a proximety switch that senses grain height in the chamber and turns the auger on and off. I would try adjusting the proximety switch as follows: Have the chamber empty and turn the screw on the back side of the switch in until it starts the auger. Then back it out 3 1_4 turns to have it set. If you still can't get the auger to turn, bypass the control circut and see if the auger then turns. If it does, your control circut is bad and needs replaced. If it does not, your motor is bad. Make sure that you have 12 volts going to the fuse holder too. For what it is worth, I am an Agleader dealer and have a used one year old control circut available that we just took out for an Insight installation! Good luck!!