Hyper_Harvest_II
Guest
The double u-joint has a threaded yoke on each end. Both threaded yokes are standard RH thread. Sometimes you need to warm up area where thread is with a torch to break loose as some have loctite installed. Also you need to hold outer end from turning by use of pipe wrench or other suitable wrench while trying to unscrew outer end with pipe wrench. I have seen where inner threaded portion can get water inside of auger and as you loosen after heating, water that comes out will be extremely hot and steaming so be careful not to get burned. Usually you will also have to remove pivot bolts on bin loader tube to allow auger to push away as you are unscrewing from threads. Hyper Harvest II