Combines Bearing on Variable speed clutch

Dryland

Guest
This is the Variable speed on the top of the feeder housing, not a clutch, sorry if that confused anyone, Too many things going at once!
 

Hyper_Harvest_II

Guest
Dryland, We usually pack both inner and outer bearings before installation.I also would recommend a new locknut when rebuilding.Have seen a couple asy. come off because nylon locknut failed to hold.One other thing that we do is to add a grease zerk to piston by drilling a hole and tapping for a 1_4"x28,45 degree grease fitting.This way you can grease once a season without removal and repacking.Make sure that you watch behind sheave closely when greasing for excess grease coming by seal.Normally when installing locknt,tighten locknut all the way down tight then back off one flat on locknut. Good luck, Hyper Harvest II
 
 
Top