Combines Bent Unloader Swing Cylinder

Years ago my shaft had a slight bend. As long as cylinder isn't damaged, just replace shaft.

Actually, I had a local shop make one for me for less than the cost of the cylinder. It has worked fine for 3 years now.

Depending on the vigor of the bend just put it in a press and straighten it. Make good cradles and line with inner tube. Also need a staight edge and patience.

the cylinder is the main part has long has you have not damaged this you can replace the shaft with no problem either get one made or buy new just make sure it is nice and smooth straightening is not really recommended has normally you end up taking the front seal out and having other probs good luck