Combines Better feeder floor anyoneIJ

Camaro92Z

Guest
YES!!! You hit the nail on the head on this one! I've had Axialflow since 1978, and have had this problem on all 3, (1460-2366 series). I just replaced the floor on my 2366 (600 hrs) that broke across the drum area ($390.00). I also thought about making my own with 3_16" (I was thinking 1_4") but didn't have time and dealer said that part was very hard steel for extended wear life (which explains breaking or cracking instead of bending or denting). I also considered the angle iron support in the hinge area, but didn't. Should have! I did repair the 1660 floor (cracked and wearedIJ hole through) by welding a 3_16" plate over the old floor about 12" back from the front face, be sure to weld across rear of plate or when the feeder chain is reversed it will catch the plate and fold over forward (believe me, it WIll!). It worked great for years. Burkharts (CaseIH dealer) said they use an 18" plate on the many machines they had repaired. I kept old floor for a copy to make a spare some day. We use the rock drum up front and have some rocks which is hard on the plate. Also corn and green stem soybeans is hard on it. Good luck! I think you're on the right track here allright. Ted cenOH
 

Silver_Bullet

Guest
Our dealer sells a plastic floor liner,It gets warped up after a while.What other input can you give on thisIJ
 

JFarms

Guest
We did some experimenting 10 years ago with plastic floor liners without much luck. The problem was the plastic would wear out in about 300hrs and the chaff and straw would build up under the plastic making for a pretty good mess when the feeder chain finally caught the plastic plugging up the feeder. We feel if we can get a floor that doesn't flex or dent as much we will extend the wearability greatly, and by using AR235 steel along with this we may have a floor that should last us for 3000+hrs.
 
You must log in or register to reply here.
 

Footer Links 1

Top