Hyper_Harvest_II
Guest
mailman13, Set and level your concave to zero according to instructions so you can make sure that your gauge on the outside of the machine matches. Then lower the concave so you have 1" clearance at the front and then drop the back of the concave to match the front clearance of 1". In other words take the wedge out of the concave. If you have tough to thresh soybeans you can sneak the back of the concave closer if needed. No wedge has been working. You will probably need to run the cylinder speed a little faster than you were used to with the stock P3.(Approx. 100 RPM). Hyper Harvest II