Combines cdf settings in wheat

NDDan

Guest
likely reved all the way if tough to thresh. Run concave up to zero on display in cab and then phisically check to see bars are nearly touching concave about 1_2 way back. If hard to thresh start at .20 and tighten if needed. If down to zero and you have three filler bars installed you will want to set front of concave a knotch tighter untill you get good thresh. Make sure you have tailing return set to rethresh. Did you get an '08 with feeder floor allready tiltedIJ What would be included with in the hyper mods you didIJ Steep helicals or anything elseIJ Are you started out with any reverse barsIJ
 

EHoff

Guest
Thanks for comments. Have zeroed the cylinder and plan to start at .10 with 3 filler bars. Have extended helicals into discharge, 2 F2 bars bolted to bottom of cage, extended 3 of 6 cylinder bars all the way to discharge. Will be running 3 reverse bars in second row from right. Have concave sey in mid position. How do I tell if I have the tited feeder floorIJ
 

NDDan

Guest
'08s have tilted floor. Otherwise dealer would know if they did it. If you looked under the front of rear feed just above transmission and see a humped up area just ahead of where rear feed tention drum is then it is likely not tilted. Factory removed that hump when they tilted the floor.
 
 
Top