YES!!!!!!!! Watch out for the timing!!!! It is important, you will blow your elbow gearbox pretty quick if get the timing wrong! The book shows it pretty good! If ya are not sure call the JD combine specialist! We run 3 9600's all have been replaced. Go ahead and replace bearings in lower charge housing when your in there. And u do have to take off the tailing elevator, looks bad but no big deal. Just be sure to time it right! And ya should have some strong men to put your charge housing back up in the hole and a couple of good aligning punches for when ya get it close! We put in the heavy augers every time. Good luck and have a safe and profitable day.