Combines Chatter in K2

[tbran]

At just off idle slow the v speed down and adjust so as to have 1_16" between lower sheaves. Then speed up. IF it runs on the pins and causes vibrations there are shims in the main shaft sheave that can be added or taken out to set the correct travel. IF this was run on the pins you could have lost the bearings again in the main input shaft.

 

[Kaye2]

I was afraid I had messed up what I had just fixed, I ran it two or three more days after the first occurrence and it didn't vibrate or make noise. I will adjust when the temp outside gets above freezing and hopefully I don't have to redo those bearings next year. Thanks for the help Tbran