skinnb
Guest
James You can reach the fitting from the bottom if you bend up a steel pipe (1_8) like comes with a new grease gun.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines Drilling Hole in PTO Housing for Zerk
SDman
Guest
Have done this on several older combines and have never had any problems with it.
guru
Guest
have carried out a few (8)and had problem with none of them u can reach it from the bottom ...but to drill teh hole it is easier to take the housing off and drill it only a couple of bolts hold it on..we found by painting a mark oppsite the nipple u can turn it with a screwdriver from below till ur mark comes to view and u will have the nipple in the right spot good luck
crucut
Guest
You will have no problems with drilling a hole through that pig iron. Use an inch and a half hole saw and drill the hole right on top towards the back. Make sure that you take a blow gun with you, and periodically stop drilling and blow out the filings to make sure they don't end up somewhere that they are not suppose to be.