Combines f3 tbran

[tbran]

Reel back and as low as possible, We like the sution hose 2.5" bolted to cuterbar as found on hyper mods section. There are sprockets available to speed up the header auger. However an F3 should walk upwards of 3.5-4MPH in beans with a 313 if the bars are new. 650 Cyl rpm and about 7_16 setting.

 

[jm]

Thanks as always, I did have one other question. you had mentioned on an earlier post of using half rounds in the concave, my dealer is telling me they did not have them for an f3. I am sure you would know and probably have the part numbers in your head. thanks again

 

[tbran]

70559226 = half round, AND HE CORRECT THEY ARE NOT ON THE F3, however you can help him out by telling him all F,F2,F3's are the same. 71139306 is the channel,71161900 is the high profile bar.71142277 is the rasp bar concave.