Combines Fan info please

Rolf

Guest
PS: For got to ask this in previous post!!!!if any one might have info on our to adjust the gain on the header hight controlIJ (It's that 800 series AHHC control that's been adapted to a flex 530!!!)
 

Geoff

Guest
Colars are only loctited on. Heat will shift them. Must let set for a day before use after re-loctiting.
 

tbran

Guest
if I undrstand your question correctly, the gain on the Smartrac lateral tilt can be increased by holding both the 'c' and 'l' buttons at the same time for three seconds, key on clutches on. It will then flash alt led lights ; hhc and lat tilt. Press the lat tilt switch to the left and it will flash the the setting . Turn the top tilt knob clockwise to increase gain the position of the knob as indicated by no. of flashes will range from a low of one to a high of 8 (too much). Turn off clutches to store new setting. IF one doesn't have lat tilt, the rate of raise and rate of lower flow rates, manually adjusted, are the 'gain' for the raise and lower.
 

tbran

Guest
Don't think loctite is necessary on the bolt on clamps, and shaft but will not hurt. And yes the flow from the header valve is the only gain on AHHC , old and smartrac. Gain is for lat tilt.