NDDan
Guest
Sounds good. I did some measureing today. With seperator grate on 9 you will have a strong 1" clearance between seperator grate and cylinder bar. On 0 the two will be about hitting. Now on this machine the right side of seperator grate would hit sweep at .5 on gauge thus sweep is a hair higher than cylinder bar. On left side of seperator grate the sweep would hit at 2.5 on gauge thus sweep is higher than cylinder bar by approx 3_16". This is because spiral nearest discharge is fastened to mounts at a different angle. This is done purposely to sweep area uniformly while using the same spirals everywhere. If you should feel the need to adjust grate closer you can trim spiral to get the clearance. Spiral does not need to be higher than bars so no worries if you want to trim. I hadn't worried about that spiral being higher for it would be rare to run that tight. Anyway thanks and keep up the good work. Dan