Combines header 1020

Where's your feeder faceplate angle setIJ Perhaps the front of the head needs to be closer to the ground.

Try adjusting springs under header and coil spring on left end for less down pressure. 1020 owners manual will tell you how.

Try adjusting springs under header and coil spring on left end for less down pressure. 1020 owners manual will tell you how.

There are some large sheets of poly that bolt under the header at the very outside edge. They hang down on chains mounted at the rear of the header. I'm not sure, but I think they are available from CIH. We run them on a 1020 and don't have much trouble. The head already had them on there when we got it.