Minniehill
Guest
I have had to replace the same in one of our heads. Just went to our local steel shop and got the peises cut. look good, works good and was inexpensive!
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines header repair question
jbull
Guest
Are these pieces stainless or mild steelIJ John
mo
Guest
I'd use mild steel. Stainless isn't worth the extra cost. After you get on to it replacement isn't that bad. Get a big rivet popper and 4" grinder cut off tool to cut out the worn section at a rib. Have new section long enough to slide under ends of remaing good bottom. cut out front overlaps and drill new holes to rivet to. Don't try to hit the old holes. That is like a trap shot at night.