Help with NH PLM GPS offset

docneyman

New member
Hi. I just installed a Raven rate control module via ISOBUS on my anhydrous applicator. It is connected to a New Holland T8390 with Inteliview IV and Task Controller. It predetermines the implement width. When activating autosteer, it is off 20 inches. When using the ISOBUS it does not allow to enter an implement offset.

I always have to enter a 10 inch offset with every implement otherwise, there is a 20 inch gap.

The GPS receiver is in the midline as is the implement.

Any suggestions?
 
Top