Dan
Guest
Must be nice corn only. Check to see you have strengthened rear feed chain strippers. I think some guys have just left feed chains on fast to help eliminate need for strippers. If you still have narrow low wire concaves and seperator grate you will want to remove every other wire from concaves and do the same with seperator grate unless you want to cut every other cross bar loose and slide on existing wire per HYPER. Install 3_4" rasp bars. Extend 2nd helical from gearbox over top left of feeder opening. I believe there is a fair picture of steping helicals into discharge area in mod section. Remove reverse bars and maybe a couple forward in favor of sharpened gussets that have been moded to prevent spinning on bolt. Don't know how Hyper stands these days on the half height bars as opposed to gussets or just leaving some bars off. If you end up with shoe over load you may want to do chaffer mod. May want to even if no shoe over load. Don't know if I forgot anything but check out mod site and ask your questions.