Combines hyperizing with a CDF rotor

[posum]

We use 2 f-2 bars at 6-o clock and 7-oclock under the last two rows. not sure how much it helps because there is more room with cdf. but it surely can't hurt. we may add some reverse bars to help in corn. also have adj. grate; we move it alot to try control loss. it should be adjustable from the cab like the concave.

 

[tbran]

When installing the cdf did you readjust the thresing grate, as in shortening the pull rods and moving up the lower eyebolts and resetting the mid-min-max gaugeIJ

 

[mailman13]

I did everything that the installation instructions said to do, so yes I re leveled and zeroed in the concave. I put in the "wedge" as instructed. First bar on bottom grate set at .6 inches when first bar on non adjustable part of concave frame at zero as per instructions. I might add that I also installed a new Agco high wire concave at the same time. I had to shorten the concave adjustment rods quite a bit as per instructions and actually had to notch out a little bit on the cage frame to get the concave zeroed because of interference of the concave back support bars. Have talked to a few others that had this issue also. Not a big deal to fix but you would think Agco could have made things fit a little better than that. I am not familiar with F2 cylinder bars so that is why I asked how and where they are installed as per hyper mods.

 

[mailman13]

Sorry the above email address is no longer correct for me. If you need to contact me post your email address and I will get back to you with mine. Does anyone know how to edit your profile on this siteIJ

 

[sidekick]

What you want are F2 rasp CONCAVE bars not cylinder bars.The ptn is in "success stories" by Tbran over in HYPERMODS.n71142277