Combines l 2 questions

been a while since we ran a l-2 but ours did a very good job cleaning if the settings aren't working the way they are go the other way we had a set of EAGER bars in ours they had every other tooth cut out and then remaining teeth hard surfaced these were some eating sons of guns nothing stopped it. sorry for no more help than this. Bob also had a modified seperater grate in it this helped also

brassring where do you get eager rasp barsIJ

I'll have to do some checking the guy doesn't live too far from me but can't find his number give me a little time and I'll get back to ya. Bob

The rebuilt bars sold by Trimpe in Seymore,IN. do a great job. My M2 runs 4-4.5 mph in 50 bu. beans with them. Also try putting the cyl. at 1_2in. clearance, which is the setting suggested by the book. It works well for me in most conditions but I will go closer in droughty beans.

What size head do you run on the M2IJ Do these bars have every other one removedIJ What is the cost of these barsIJ Boy, I'm full of questions ain't IIJ Thanks

I have a 15ft. head on the M2. The Trimpe bars have every other tooth taken out, the remaining teeth are built up higher than before and hard surfaced. Much more agressive

Thanks for the info. Do you have a phone number, e-mail address,or website for TrimpeIJ Thanks again, T3

T3 call j72 0r ol boy about Trempe bars.

Would the HI-lOW cylinder bar concept work on the l2 IJ Why not put one cut out welded up cylinder bar followed by one regular height bar. Total of 4 welded up cut-out bars and 4 regular bars. They say the tall bar flips it up and the short bar rolls it resulting in better threshing SO... WHY NOTIJIJIJ