Hyper_Harvest_II
Guest
When you had the torque sensor asy. off, did you take it apartIJ Have seen the cams get gaulded and not allow torque sensor to tension belt properly.With the belt in place and torque sensor in place insert a pry bar behind inner sheave and rest pry bar on the concave adjustment cam and see if you have any play in input shaft.You should have zero movement.Was the output shaft tightIJ Anything noticeably wrong with the cylinderIJShift gearbox to neutral and see if cylinder is way out of balance.Paddle missing from discharge,bent cylinder bar,first star on drive end cracked where it attaches. If it was me, I think that I would remove the cylinder for no longer than it takes and take a look at it. Also you could run machine without the cylinder and see if it still vibrates. Hope you find something, Hyper Harvest II