Combines N6 wheat settings ASAP

[mike]

The recommened settings are as follows: cyl. speed 800-1000, concave 5_8, chaffer3_4, sieve3_8, fan choke 7 These suggested starting points are taken from a 1980 crop saving guide for N-series Gleaner combines. If any modifications have been made then these settings will vary. Good luck on your harvest, mike

 

[mike]

The suggested settings are as follows: cyln. spd., 800-1000, concave: 5_8, chaffer:3_4, sieve:3_8, fan choke: 7. These starting points were taken from a 1980 crop saving guide for N-series Gleaner combines. If any modifications were made then these points will vary. Good luck with your harvest., mike

 

[Kelly]

Mike's settings are a guideline but I would run that concave between 1_4 and 3_8 depending on conditions. The other settings are a good starting point. The sieve might need to be tightened up a bit and the chaffer opened up a bit. Try 900 on the rotor speed. Kelly