Combines NEW 9560 question

[dutch_dust]

I have had the same problems. If you want to program the buttons one Icon must be activated (shows arrows in front and behind). The operator manual shows a couple of ways to oparate the system. You have to program the buttons in a special order if you want them both working. If you try it the other way it doesn't work. Read the manual and try it exactly they tell you. When it's works it's easy and very useful. Good luck.

 

[Seen_the_Green_light]

Simple answer, when the pressure setting is showing that is your height.

 

[cattlefarmer]

I have run one on a 9660 for 1 season. The height is automatic when operating with the hydraflex. The height is technically not adjustable, just the ground pressure. (However low ground pressue will translate to a higher cut.) Just use the height adjust dial to change the hydrafex pressure. (The higher the pressure the less ground pressure.) That explaination might be about as clear as mud. If you have anymore questions e-mail me.

 

[nod]

Is the 9560 cab different from the other JD cabsIJ If so howIJ

 

[Wind]

No, the cab is no different, the same one as the other machines.

 

[nod]

Sounds about right. My JD dealer is dumber then a box of rocks. He told me that JD came out with a different style of cab and before they switched all the combines over to them they just put them on the 9560 to see how well they were liked by the farmers. He claims the farmers really like them!

 

[dale]

Just remember the higher pressure is less ground pressure. High pressure in wet conditions, low pressure in dry conditions for a lower cut.

 

[countrytime]

thanks guys for all the input...I finally figured it out...I was trying to make the auto height resume do the floating... but now I see that it all works on pressure. thanks again,, and by the way, the cab is no different, but the seat is by far better than the one on the 9500 and the a_c controls are in the front instead of beside the the left shoulder....also like that small steering wheel..