Dan
Guest
Rolf, You shouldn't need to unhook at the sensors. Just leave the plug unhooked between the front and header (header and combine). Than the module knows to go off feeder house sensor. They could of had a switch so you could tell it to use the front sensors instead of feeder sensor but it's easy enough to just unplug harness plug when flex head cutter bar is locked up. If you needed to program return to cut that would be done with harness unpluged. Thanks for the pictures and good to hear the P4 proto type is working as planned in the land down under. Sure is weard to be getting currant harvest reports when it is -5 degrees F. Not complaining it could easily be -30F