Combines R40 Raspbar Installation

Fishdog, Have you pulled every other wire from seperator grate or cut every other cross bar loose and slid it forwardIJ Next find the position you want to install your F2 bars(Usually 6 o'clock).If you are going to mount between existing crossbars,I would suggest narrowing F2 bars so they will set down on wires and then using a piece of metal 3_8"x3_4"x3"-4" long to attach to the bottom side of wires for retension.Have played with the height of the F2 bar by adding different thicknesses of metal to bottom side to acheive more tumbling action of material flowing by. Don't forget that you can add more than just two F2 bars. let us know if you have further questions, Hyper Harvest II

To Hyper Harvest II--I will have done all the cage mods when I am done. My question is--will these mods work with a sunnybrook rotor, Generation 1. I purchased this rotor because they had a special and it was cheaper than new bars and extensions and the previous owner ran something hard into the rotor and three of the cross members were bent)

Fishdog, You should not have any problems with the Gen.I cylinder. Just make sure you do not have any reverse bars. Good luck, Hyper Harvest II