Combines R40 Upgrades

No, unfortunatly there are no n for your questions. However if you click on Hyper mods to your left here you can find detailed instructions as to your needs. Take a good look at Tlangan's cylinder setup. Depending on your crops harvested you may or may not need the wide spaced bars. There is a good increase in capacity if you use them however. Inspect the helicals as your R 40 did not have the chromed cage_helical more than likely. Also look at your grate to inspect for wear on the lH side. IF it is not worn too bad it can be releveled. And yes the F2 bars or any type of retard system will attack rotor loss if incurred.

I am a fan of the Sunnybrook rotor, so I would recommend it, although the Gen. 1, I have no experience with. Hopefully others can get more specific on that.

There is not anything available from AGCO parts for the helical stuff. We ordered one long helical and one short one and used them - still had some left over. Hurtt Equipment -might- be able to set you up with a bolt-in helical extension over the feeder corner - seems like I read once where they offered them for the large P3, but don't know about the small P3. There is a link to their website on the Hyper Mods "links" page. As for the extended cylinder bars into discharge, AGCO offers a "Performance Kit" from parts, which is eight half rasp_half discharge paddle - but you only need four of them. loewen Mfg. offers full rasp extended bars for discharge as well as 1_2 rasp 1_2 paddle. You'll want four of each. Good luck- Tom langan