tbran
Guest
2700 hi idle no load
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines R50 Deutz high idle setting
vstk
Guest
Most often no adjustment of the pump is needed. Put the throttle lever to full throttle with the engine not running. go to the engine and make sure the lever is against the stop on the pump. Also make sure there is a bit of over travel on the linkage. that is to say that the spring on the clevis is collapsed some. This is often the problem. Adjust it with the big nuts on the cable. If the cable moves hard it is most likely time for a new cable.............VSTK
tbran
Guest
Also the little bolt that attaches the cable arm to the pump itself will back off.