t_leslie
Guest
I think you will have to rigg up another cylinder. Is the n6 axle stout enoughIJ
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines R50 steering
Bert
Guest
The axle had been reinforced, looks as if it was done well. Can you buy the brackets necessary to install 2 R50 ramsIJ
R_O_M
Guest
Suggest you also check each king pin where the flat steel plate for the tie rod is welded on. Some had continous welds around the king pin_ axle shaft. This created stress cracks thru the shaft, fatigued, broke and the rear wheel fell off. Very expensive if it went thru the sieve box! later versions had 3 short welds which limited stress crack propogation.