Combines Replacing auger tube

[Hyper_Harvest_II]

You will need to remove clean grain ele. door,then remove rivets from outside bearing plate,removed bearing and flanges,remove bolts from outside bearing plate and remove plate. On the inside will be a rectangle cover that is bolted in place and will need to be removed. Also some more rivets will need to be drilled out. Once you get to this point you should be able to remove front plate that ele. door pivots on and also rear plate that latch is welded to. Disconnect clean grain chain. Then unbolt tube from frame and it should drop enough to allow removal of tube for replacement. Reassemble in reverse order. Hyper Harvest II

 

[lee]

Thanks Hyper Harvest II. I was hoping if I had everything loose it would drop enough to slide out. Steve