CarlP
Guest
Go with the Crary or stock case IH....if the Tiger jaws are the smaller sections, they are very inferior to a standard size sickle section, the Crary spring loaded hold down is very good.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines replacing cutter bar on 1020
wolffman
Guest
I've ran Crary and Tiger Jaws on Gleaner and dislike both. Tiger Jaws wear extremely fast and Crary would cut a little better,but not near as well as factory 3" on my CIH 1020. Shoup offers 3" sections,guards,and wear plates for factory 3". At a lower cost than my dealer. Your dealer might offer a kit at a special price. Good luck! Wolffman
colwood56
Guest
We have found that SCH cutting bars with course teeth works the best in soybeans.
weaverism
Guest
How fast can you run without shatteringIJ
gms
Guest
dont know just looking at buying it