Combines rotor modification

[tbran]

Do yourself a favor and get all 3_4" spaced bars or cut out every other ridge on the 1_2" Bars and rebalance in pairs. We run 4 paddles on most hyped units with 4 cylinder bars ran to 1" of the end. We also run steep pitched helicals over the thresher and transition them into regular pitch over the sep. This helps eliminate the wear your are experiencing. look at the helical on the extream RH end, when the mid helicals get to 60% of this one replace them. Keep in mind they can be reversed and swapped if not worn too far.

 

[chris]

Do you cut the four paddles and weld bars to them or leave the paddles stockIJ

 

[tbran]

Paddles MUST be cut back to the size of the discharge chute and cylinder bars added and welded in to the back up bar and paddle OR put the new longer bars in.