Check gap between magnet and sender on end of shaft.May be too wide.
Mad_Mechanic Guest Nov 16, 2003 #1 Check gap between magnet and sender on end of shaft.May be too wide.
Redhotnrolli_n Guest Nov 16, 2003 #2 I've seen the time when the sender or switch at the magnet was defective. Also, the two small wires that plug together in the same area, carefully unplug them, use electronic cleaner then re-plug them back in. Sometimes that's all it takes.
I've seen the time when the sender or switch at the magnet was defective. Also, the two small wires that plug together in the same area, carefully unplug them, use electronic cleaner then re-plug them back in. Sometimes that's all it takes.
