Combines spacers for R50

We have an R42, before we took delivery of it last year, we had the dealer rotate the 24.5_32's so they would run down our 30 inch rows. We no-till and it was important to us that we leave our stalks standing. I would check to see which way the rims are mounted. The are offest of the center of the rim. The only time I run down stalks is on tight curves. Note the 24.5_32's will be tight but but should beable to run between 30' rows.

I have spacers on the front drive tires and adjustable rear axle so it does not run on rows. I believe it was an AGCO part.

I don't think the wheels can be turned to fit the rows. I couldn't on mine. I bought spacers from Unverferth. 1-800-322-6301 Well worth the money.

If you have the large finals(9 1_4" center hole or so)you can get a set of 6 1_4" spacers from a R62 or 72, this is what I did for our 52. We have 30.5's and it leaves 98% of the stalks standing and is much easier on the tires than staubing them. Make sure to get the bolts and washers with them when taken off the unit, 20 grade 8 bolts 8" long will cost your about $6.00 each. It was a good thing for us for no till and the combine stance on hills takes away any fears being loaded below terraces, the additional plus is the room created for hookups and maintainance, 6" seems like a foot in there, wish more things were that way. Haha Gleamer