R_O_M
Guest
By the stainless steel accelerator rolls, I assume that you are refering to the folded full roller length, bolt on sections. We could probably sell you ours which, if they weren't stainless, would now be rusting in the back of the shed! I had a post some time ago on these. We used them for two seasons and then took them out. They did not seem to work as well as the rubber AGCO ones. We put this down to being 3mm sheet, they left very large gaps around and between the blades and did not accelerate the grain sufficiently which is essential if the Gleaner accelerator roll _ fan _ sieve system is going to work as designed. They acted somewhat similar to moderately worn rubber sections. They were also about 3mms short on each fold or leg even though they measured the same diameter as the rubber sections. This effect was caused by the thiness of the 3mm thick blade section compared to the about the 20 or 25mm wide flat top of the rubber sections. We harvest a lot of lentils and they definitely damaged and split a lot more lentils than the rubber sections. We have tried some plastic covered sections but they wore out in less than a season so it was back to the genuine rubber covered article, take a deep breath, wince, groan and pay up!