Feedlot Guest Aug 17, 2003 #1 I always use a large tap,cant remember size maybe 1' or 1.25 . Use impact wrench with square socket and run it down till hits bottom and it will push out bushing. Be careful and use safety glasses!
I always use a large tap,cant remember size maybe 1' or 1.25 . Use impact wrench with square socket and run it down till hits bottom and it will push out bushing. Be careful and use safety glasses!
kirk Guest Aug 19, 2003 #2 I use a small stone on a die grinder and grind thru length of bushing on opposite sides. they'll almost fall out then. takes me about 3 minutes.
I use a small stone on a die grinder and grind thru length of bushing on opposite sides. they'll almost fall out then. takes me about 3 minutes.