Combines Straw Walker sensor K2

ewbeye

Guest
The sensor is above the walkers, in the area below the fuel tank. look for a loose wire. It may not have a problem. Check the Tattletail II in your upper cab console for mice chewing on wires, mouse droppings, or mice nestsIJ When They chew, it can bare lots of wires or even mess with the circuit boards in those plastic boxes that contain the alarmsIJ How to get rid of miceIJ Thoroughly clean grain from machine after harvest. Remove the cab filter and any paper items in the cab. Open the console door and upper air filter door and load them up with moth balls, dryer sheets, or whatever you think smells nasty to mice. Opening the cab door and window may also help during storageIJ
 

jake

Guest
Sometimes these sensors switches get full of chaff. You may have to remove it and clean it for it to function properly.Best way to do this is to swing the chopper back out of the way. There is also an adjustment on the the swith actuator that can be tightened to lesson the sensitivity.
 
 
Top