bm
Guest
I've seen it if you're running the slow-down kit on it, otherwise, no.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines STS Feed Acclerator
customcutter2
Guest
do you have it set on the slow speed and running to much crop in.
boyblue
Guest
We have tried to run it in slow speed and high speed does not seem to make any differance in high speed it just seems to burn alittle faster. This started with wheat in ND and has stayed until we finished bean so far no trouble in corn
mech1
Guest
the problem is the mmagnet turns on the shaft the best way to cure this is to remove the magnet and put some emery cloth on the shaft then put the magnet back on then tighten the screw and the magnet will grip the shaft and won't spin causing the sensor to go off.