Pull the tach module from the dash. On one side there is a set screw for adjusting your alarm set point, adjust until it alarms at the rpm you want. It takes a little fine tuning but not a big thing. Pete
Should be able to set down to 100 RPM below rated. N7 was rated at 2200 (correct me if I'm wrong). So you should have no trouble keeping overload beaper off at 2100 on that vintage machine.Good luck
Yeah just read operators man . Says upper alarm threshold may be adjusted,thelower is not. (opposite to my wife ) Will have a play this afternoon.(with combine ) Can always add aftermarket type if all else fails i guess. peng.
Whatcha do'n reading the operators manualIJ Not very manly if you ask me. Kind of like asking for directions...... especially if the wife is in the car. Pete
Whatcha do'n reading the operators manualIJ Not very manly if you ask me. Kind of like asking for directions...... especially if the wife is in the car. Pete
Yeah i did think about that as being a bit girly. Sorry. Better get some mates around and watch some women jelly wrestling and monster truck racing while consuming some ale's . What was i thinking peng