Combines embarrasing but

[Dan]

Tim, I tried that this fall and for some reason it don't work on our machines. When I slow up jack shaft that runs clean grain, tailings, and spreader the light won't go out for speader when run on slow speed even after adjusting module. I have been installing 10 leg sensing collars now and light stays off just fine. The 10 leg collar is used on the twin spreader system of the old machines. For the spreaders with 1 1_4" shaft I cut the 10 leg disk off of the 1" lock collar and install on 1 1_4" collar. Thanks anyway Pastor or Doc Tim. Have a good day. Dan

 

[T__langan]

Well, I ain't no enjineer by no means but perhaps if the sensors are mounted at exactly 180 degrees from each other, they are both picking up a leg at the same time, thus sending only one signal to the module. Maybe they need to be offset just a bitIJ Dan's idea sounds easy enuff anyhow for the spreader but maybe for another shaftIJ Tom l.