Combines header clutch

[Kornkurt]

If the design is the same as a 750 and 850, there are threaded holes in the clutch where you can run a special setscrew and lock the clutch. You will need to align the holes and the setscrew will go into the inner part and lock it. Hope this helps.

 

[whizz]

the setscrews are already in the clutch you just move them round

 

[swtvid]

On a deferent machine but same type of clutch we had a problem where it would kick out circuit breaker finely found a wire that was worn through and sorting to chassis. Good luke Swtvid

 

[ski_whiz]

It can be considered normal to require installing the pins to run the corn head, as the manual recommends it. Although I have run without them before. The only way you'll know is to try it under load. If it works at all the clutch coil should be ok. Check for proper assembly, bearings condition and clearances.

 

[jhoag]

Put brand new clutch on 860 and had same problem. They wont run with a 6 row head. I do not know why.