Gman
Guest
Thats the way we do it all the time.It's fairly easy and works well.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines l3 Grain Tank Repair
t_leslie
Guest
I have the local sheet matal shop cut and bend about a dozen at a time for me... I have him make them wide enough to do and l and if we do an M we have to trim it off abot 10 inches... Works good...We remove as much or rusting old metal as possible... and lay in a good bead of silicone betwen new and old...
venturis40
Guest
we go to the local junk vendor and get stainless sheet metal and slide it under the auger
l3
Guest
We made one with a piece of sheet metal. To get curve in the bottom, we nailed two 2X4's together about 8-10 inches apart, put the sheet on top and drove the front tractor tire over it (between the boards). We also rivited it in place, with silicone on the seam.