tbran
Guest
shim the beater BEHIND the sprocket between the brg collar and the clutch hub with shims or washers.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Combines m3 feeder beater sprockets
tbran
Guest
38 tooth will destroy the beater in corn. 44 is for corn and soybeans - smaller for small grain. AS stated in post below - correctly shim the clutch between the beater brg lock collar - which will be worn bad - and the square washer on the clutch back. 500 springs will not add any tension unless the back is shimmed.
dean
Guest
Do you recamend 6 or 8 springs after it is properly shimmedIJthanks for help everyone.dean
tbran
Guest
6 will do it. 8 may break chain if it is shimmed propery. Some have used a 50H (rare) chain.
jbirnsch
Guest
My dad had trouble with his C2 plugging at the feeder beater. He replaced the springs with pipe and problems were over. Hw only broke the chain 2 times after that. Jason